DLPC3478: [DLP3478] Trigger Out 2 Delay timming

鈴木辰雄

Prodigy 105 points

Part Number: DLPC3478
Other Parts Discussed in Thread: DLP3010LC

Hello,
The data sheet and the GUI are different. (Trigger Out Delay Timming)
Which is true?

(1)DLPC3478 datasheet(DLPS111B –APRIL 2018–REVISED JUNE 2019)
page32,fig16

(2) DLP3010LC GUI 2.2.0.5

Regards, Tatsu

over 4 years ago

0 Vivek Thakur over 4 years ago

TI__Mastermind 22830 points

Tatsu-san,

Thank you for bringing this to our attention. Very likely ,it is bug in the GUI interface. We will investigate and getback.

regards,

Vivek

0 Vivek Thakur over 4 years ago in reply to Vivek Thakur

TI__Mastermind 22830 points

Hello Tatsu-san,

We did confirm that it is bug in the "display of GUI" only. We will fix this issue in the future release. There is no defect in the actual device or firmware functionality.

The firmware functions as described in datasheet.

Once again , thank you for bring this issue to our attention.

Thanks and regards,

Vivek

0 鈴木辰雄 over 3 years ago in reply to Vivek Thakur

Prodigy 105 points

Hi

Thank you

BUT

In my environment, the DLPC3478 device behavior and GUI display are the same.

tatsu

0 Vivek Thakur over 3 years ago in reply to 鈴木辰雄

TI__Mastermind 22830 points

Hello Tatsu-san,

Thank you for verifying it. We also investigated and reviewed the internal design documents. The following is the findings:

1. The information in datasheet is incorrect. The only rising edge of the trigger 2 should be delayed by Td2. The falling edge will not be affected. We wil update the datasheet to fix this error.

2. The GUI and firmware are correct. The operation is as per definition.

regards,

Vivek

0 鈴木辰雄 over 3 years ago in reply to Vivek Thakur

Prodigy 105 points

Hi

Thank you

This resolved my issue

DLP®︎ products

DLP products forum

DLPC3478: [DLP3478] Trigger Out 2 Delay timming