DLP6500FYE: Struggle uploading patterns to DLP lightcrafter

Hi Andrew Dickins,

As a first step, you need to record operations being performed on the GUI by enabling "Enable Command Logging" option in Batch file window, you can save all the commands being recorded to a text file.

Create a new firmware by including this batch file and you can trigger this batch file using USB/I2C Command.

These two Videos gives short introduction about how to save Batch file, Create firmware and Pattern modes.

Getting started: TI DLP® LightCrafter™ 6500 & 9000 EVMs Pt 2

Getting started: TI DLP® LightCrafter™ 6500 & 9000 EVMs Pt 3

EVM user Guide  Section 3.6 Pattern Modes and Section 3.7 Batch Files provide details about creating and saving batch files.

DLPC900 Programmers Guide Section 2.3.8 Batch File Commands explains commands used for executing Batch file stored in firmware.

Thanks,
Shivakumar

Hello Shivakumar, 

thanks for your response, I've tried following the instructions laid out by the material you've shared but when I try and execute batch files I've uploaded to the firmware the projections I made in pattern mode don't happen.

How early on do you need to start recording the command logging for it to work in full? and how can I ensure that the projector has the image files stored on it's memory ready to use when the batch files are triggered? as far as I can tell the batch files are just a series of text commands and do not include the images.

Thanks,

Andrew