Hi, Ti team,
1.MAPSEL/LFMODE/BKWD/REPEAT can through the way of software registers configuration, hardware and not pull/pulldown resistor reserved?
2.Can unused pins be floating? eg;I2S
3. Is there a "CMLOUT" pin for test eye diagram available?
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi, Ti team,
1.MAPSEL/LFMODE/BKWD/REPEAT can through the way of software registers configuration, hardware and not pull/pulldown resistor reserved?
2.Can unused pins be floating? eg;I2S
3. Is there a "CMLOUT" pin for test eye diagram available?
Hello Yang,
1) LFMode in reg 0x04, MAPSEL in reg 0x13, BKWD Mode in reg 0x04, Repeater Mode can't be overriden using register.
2) Yes, please refer to datasheet. It is stated that these pins have internal pull down.
3) Serializers do not have CMLOUT. This function is available only on DES.
You may unplug the cable and measure eye diagram directly at the connector, or on the AC-Coupling capacitors.