Dear Specialists,
My customer is considering TL16C2552 and has questions.
I would be grateful if you could advise.
---
I have a question about TL16C2552.
① When using the MF pin as OP by AFR,
When INT-Enable is enabled by the 3rd bit of the MCR register, it seems that the MF pin is forced to go low.
Is this recognition correct?
② If the recognition of ① is correct
Is there a way to control the MF pin out of sync with the INT-Enable enable / disable setting?
Currently, UART-IC is used for RS485 / 422.
The MF terminal is used as a transmission permission signal (allowed by High).
During full-duplex communication, I'd like to set MF to High (transmission permitted state) and INT to Enable state simultaneously.
---
I appreciate your great help in advance.
Best regards,
Shinichi