ESD224: Block diagram inquiry

Charles Zhang1

Part Number: ESD224

Hi Team,

The block diagram shows resistors between connector side and system side, what's the purpose of these resistors? And what's the impact of shorting C pin and S pin together?

Regards,

over 3 years ago

0 Parker Dodson over 3 years ago

TI__Mastermind 49742 points

Hi Charles,

We are on holiday today and will be returning 7/6/2021 - we will answer your inquiry within 24 - 48 hours.

Best,

Parker Dodson

+1 Matt Smith3 over 3 years ago

TI__Expert 8486 points

Hi Charles,

The resistors are there to increase clamping performance of the device. If the C and S pins were shorted together, the device would not clamp properly during an ESD event, and possibly damage your system.

Regards,

Matt Smith

0 Charles Zhang1 over 3 years ago in reply to Matt Smith3

TI__Expert 3310 points

Hi Matt,

May I know this resistance between CS pins?

Regards,

+1 Matt Smith3 over 3 years ago in reply to Charles Zhang1

TI__Expert 8486 points

Hi Charles,

The DC resistance is about 3.6 Ohms.

Regards,

Matt Smith

Interface

Interface forum

ESD224: Block diagram inquiry