The TI E2E™ design support forums will undergo maintenance from Sept. 28 to Oct. 2. If you need design support during this time, contact your TI representative or open a new support request with our customer support center.

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

SN65HVD230: The RS pin must be pulled down to receive the correct bus data

Part Number: SN65HVD230

Hi team,

The customer's current situation is: SN65HVD230 in listen only state, after receiving the RX pin signal, STM32 MCU must first pull the RS pin down can receive the correct bus data.

If the customer's this node is in the low-power mode, only needs to receive bus data and does not need to send data, can the SN65HVD230 be in the listen only mode all the time? That is, can SN65HVD230 receive the correct bus data without pulling down RS pin?

Best Regards,

Amy Luo