TCA9535: Port State Before POR

Hideki Hayashi1

Expert 5990 points

Part Number: TCA9535

Hi team,

When there haven't POR yet, how is the output state at each pin (/INT, SCL/SDA, Px)?

Best regards,

Hideki

over 2 years ago

0 Tyler Townsend over 2 years ago

TI__Mastermind 23493 points

Hi Hideki,

The first time this device is powered on for its application, the following pins will go to their default state:

SCL/SDA = High-Z inputs

Px = High Z- inputs

/INT = Active low Output connected to VCC through pullup resistor (typically 10kohm)

Regards,

Tyler

0 Tyler Townsend over 2 years ago

TI__Mastermind 23493 points

Hi Hideki,

I realize that this may not be the answer you are looking for. Give me till 5pm tomorrow to get back to you with a more correct response. You are interested in the output state of each pin before device is powered on for the first time, not after a POR, which I gave below.

Regards,

Tyler

+1 Tyler Townsend over 2 years ago

TI__Mastermind 23493 points

Hi Hideki,

The state of each pin is High-Z before power on.

Please let me know if you have anymore questions.

Regards,

Tyler

0 Hideki Hayashi1 over 2 years ago in reply to Tyler Townsend

TI__Expert 5990 points

Hi Tyler,

Yes, the latter is what customer needs to know. Appreciated for your support, and thankful for your self correction.

Best regards,

Hideki

Interface

Interface forum

TCA9535: Port State Before POR