• State TI Thinks Resolved
  • Locked Locked
  • Replies 2 replies
  • Answers 2 answers
  • Subscribers 34 subscribers
  • Views 288 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TCA6418E: GPIO

Denny Huang
Expert 7170 points
Part Number: TCA6418E

Dear team

Does the GPIO port of TCA6418EYFPR need to be pull-high?

Many thanks

Denny

  • 0
    Guru 308010 points

    The GPIO_PULLx registers can enable the internal pull-down resistors. There are no internal pull-up resistors.

    Any unused inputs need to have a pull-down or pull-up resistor to prevent it from floating.

  • 0
    TI__Mastermind 26776 points

    Denny,

    The device by default starts up with all GPIO ports configured as inputs with a 50 kΩ pull-down. Clemens is correct, depending on your design case, you should avoid a situation where an input is left floating. If you tie unused pins, choosing a pull-down to GND rather than a pull-up might provide marginal current consumption savings.

    Best,

    Danny