Hi Team ,
We are using P8B296 part in our design .
Could you please review the attached schematic section and share your feedback on same .
Regards ,
Divya
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi Team ,
We are using P8B296 part in our design .
Could you please review the attached schematic section and share your feedback on same .
Regards ,
Divya
Hi Divya,
Here is my schematic review:
The hardest part with this device is tuning all the resistances so that your delay isn't so bad. This is especially important when you are using very long cables with higher capacitances. I wrote this E2E post on how to tune this device. What you will have to do is change your SCL low time based on the delay in your system. If you have any questions let me know.
Best,
Chris
Hi Chris ,
Thanks for your valuable review .
i. yes we changed one of them to 1uF
ii. Sure will make C41 and C53 DNI .
iii. we are using a cable length of 1m ,(Type-C cable)
iv. Sure we will tune the SCL low time according to system delay .
Thanks ,
Divya
Divya,
Thanks for the follow up. Can you click the "This Answer Resolved my Issue" button on Chris' post? This helps with our internal tracking of threads.
Regards,
Eric Hackett