This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

FPC402: i2C downstream remote access

Part Number: FPC402
Other Parts Discussed in Thread: FPC401

We have some problems in performing downstream remote access on i2c bus. 

In a forum

FPC402EVM: Downstream I2C access is not acknowledged by FPC402 - Interface forum - Interface - TI E2E support forums

there is a reference to a manual Section 2.70 for address program details that is not available in the web site.

Is possible to have this manual or something like?

"Sorry for the delay on your request. I've just granted you access to the FPC402 documentation including the full confidential datasheet, programming guide, SDK and EVM userguide. Except for the sections related to the I2C addressing of the device and ports, everything else should be the same as that of the FPC401 that you have been using, so you don't need to change the registers too much.

Please go through the Section 2.70 in the FPC402 program guide and configure the desired address for port 0 device 0 accordingly."

Regards

Emanuela Vandi