Hi team
Regarding INH pin of the internal block diagram of TCAN11625-Q1, INH terminal is connected to gate of the FET.
I believe this is wrong.
INH pin must be connected to the drain of the p-FET like below, correct?
Regards,
Hirata
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi team
Regarding INH pin of the internal block diagram of TCAN11625-Q1, INH terminal is connected to gate of the FET.
I believe this is wrong.
INH pin must be connected to the drain of the p-FET like below, correct?
Regards,
Hirata
Hi Hirata-san,
Yes, this is an error in the datasheet graphic. The next datasheet revision will have a corrected figure showing the FET driving the INH signal to VSUP as shown in the TCAN1167 datasheet.
Regards,
Eric Schott
Hi Eric-san,
Thank you for the answer. I understood.
I appreciate your support.
Regards,
Hirata