• State
  • Locked Locked
  • Replies 1 reply
  • Subscribers 32 subscribers
  • Views 115 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DS160PR810：Interface forum

xinyu chen
Prodigy 25 points
Part Number: DS160PR810

DS160PR810 uses its pin mode. After the data table is configured according to the data table, only four channels are detected. I use eight channels to display four channels, but I use four 2-channel projects respectively, but only one can pass

  • 0
    TI__Genius 10240 points

    Hi Xinyu,

    Could you please clarify a couple of things for me:

    • MODE pin is set to L0 (1kOhm to GND).
    • How many channels are you intending to have active on your setup using DS160PR810? I'm not quite sure I understand when you say you use eight channels to display four channels.
    • Are you pulling up PD0 and PD1? In your diagrams, you show both pulled high and pulled low.
    • Please confirm that your intended EQ settings are for EQx_1 = L2, EQx_0 = L0 --> EQ Index 8 (from datasheet).

    Best,

    David