This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DP83848I: 10Base-te test pattern output

Part Number: DP83848I

Hi Team,

I would like to know how to set up continuous "0" data output.

Which registers must be set?

I found the continuous "1" data output setting in the CDCTRL1 register bit0:1 = '11' in the datasheet.

Best Regards,

Kenji

  • Hi Kenji,

    May I ask why are you looking for '0' data output?

    Compliance test should detect the pattern automatically. If you are doing compliance test, make sure set your PHY into force 10mbps mode

    --

    Regards,

    Hillman Lin