TMUXHS4412: MUX&DEMUX INTERFACE FOR PCIe AND SATA Signals (TMUXHS4412)

vinay kumar

Part Number: TMUXHS4412

Tool/software:

Hi,

I have attached a Schematic design of MUX & DEMUX Interface for PCIe and SATA Signals (TMUXHS4412). Can anyone please confirm the design is correct or if any changes need to be done?

Regards,
Vinay

MUX&DEMUX INTERFACE.pdf MUX&DEMUX INTERFACE.DSN

over 1 year ago

0 Brian Zhou over 1 year ago

TI__Guru*** 148960 points

Hi Vinay:

It's Sata signal or Sata express signal? AC caps are different between them.

Regards

Brian

0 vinay kumar over 1 year ago in reply to Brian Zhou

Prodigy 140 points

Hi Brain,

SATA Signals is used and not the SATA express signal.

Regards,
Vinay

0 Brian Zhou over 1 year ago in reply to vinay kumar

TI__Guru*** 148960 points

Hi Vinay:

You need to add AC cap on TX lanes if there is no Ac cap on page 9 and 12.

Regards

brian

0 vinay kumar over 1 year ago in reply to Brian Zhou

Prodigy 140 points

Hi Brian,

Required AC Caps is provided for the TX Lanes in page 9 and page 12. Anything else need to be taken care in this design?

Regards,
Vinay

0 Brian Zhou over 1 year ago in reply to vinay kumar

TI__Guru*** 148960 points

Hi Vinay:

other than AC cap, everything else is good.

Regards

Brian

Interface

Interface forum

TMUXHS4412: MUX&DEMUX INTERFACE FOR PCIe AND SATA Signals (TMUXHS4412)