logic low failsafe option for ISO7230C

Trung Ngo Minh

Prodigy 210 points

Other Parts Discussed in Thread: ISO7230C, ISO7641FC

Hello,

Now, using ISO7230C High Speed, triple Digital Isolators for Digital Servo development.

I want to using a logic low failsafe option. in red line on table, I want make sure that OUTPUT(OUT) is Low Level.

could you tel me about this matter?

over 13 years ago

0 Saleem Marwat over 13 years ago

TI__Genius 11205 points

Please check out our new isolators below for fail-safe output LOW option.

http://www.ti.com/lit/ds/sllse89a/sllse89a.pdf

We currently don't have 3:0 (3 forward, 0 reverse Ch) option, but we have 4:0 and 3:1 options available that can be potentially used. Some of these devices are released and others are getting released soon.

0 Trung Ngo Minh over 13 years ago in reply to Saleem Marwat

Prodigy 210 points

Saleem Marwat,

When ISO7641FC is released?

Regards, Trung

0 Saleem Marwat over 13 years ago in reply to Trung Ngo Minh

TI__Genius 11205 points

We're working towards release next month (December) but worst-case, it may happen in January.

0 Saleem Marwat over 13 years ago in reply to Trung Ngo Minh

TI__Genius 11205 points

We're working towards release next month (December), but worst-case it may spill into January.

0 Trung Ngo Minh over 13 years ago in reply to Saleem Marwat

Prodigy 210 points

Saleem Marwat,

Thank you very much!

Regards, Trung

Interface

Interface forum

logic low failsafe option for ISO7230C