DS100DF410 : Can replace DS100RT410

HORI KOJI

Intellectual 570 points

Other Parts Discussed in Thread: DS100DF410, DS100RT410

Dears

I'm evaluating DS100DF410. I already finished making hardware and software.

But I don't use DFE function.

Can I replace from DS100DF410 to DS100RT410 ? No need to change hardware and software ?

Thanks

Best Regards

Koji Hori

over 9 years ago

0 T.K. Chin over 9 years ago

TI__Expert 3175 points

Hi Koji San,

Yes. DS100DF410 is pin-to-pin compatible to DS100RT410.

On software, there is some register programming in order to use the DFE feature.

regards,

TK Chin

0 HORI KOJI over 9 years ago in reply to T.K. Chin

Intellectual 570 points

Dear Chin San

Thank you very much for your prompt reply.

I understood that DS100DF410 is pin-to-pin compatible to DS100RT410.

For this project, we don't use DFE feature, therefore we can use the register which already made by DS100DF410 if I replace to DS100RT410 ? my understand is correct ?

If there are some check point about register, could you please teach me.

I would like to reuse this register of DS100DF410 to DS100RT410, if it is OK. DFE feature is no need.

Thanks

Best Regards

Koji Hori

0 Casey Morrison over 9 years ago in reply to HORI KOJI

TI__Intellectual 1985 points

Hi Koji,

Yes, the register set is the same between the DS100DF410 and the DS100RT410. The DFE control registers will not be available/functional in the DS100RT410, but as you said, you will not be using the DFE, so this does not matter.

Regards,

Casey

0 HORI KOJI over 9 years ago in reply to Casey Morrison

Intellectual 570 points

Dear Casey-san

Thank you very much for your reply !

Your reply is very helpful for me.

Thanks

Best Regards

Koji Hori

Interface

Interface forum

DS100DF410 : Can replace DS100RT410