Hello everyone, I need serious help about my TI card. Couldn't manage to install driver properly and because of this, Pc(win8) can't see my firewire audio interface I guess. I searched a bit and found this post in here:
http://e2e.ti.com/support/interface/digital_interface/f/130/t/236374.aspx
"
Hello Mike,
I am not very clear on the question, win 8 does support IEEE 1394, are you getting a yellow bang?
what TI device are you using?
We have seen a yellow bang on some devices in win8 coming from a OS resource allocation problem with the PCIe-To-PCI bridge.
If you are getting a yellow bang please see the attached document.
Regards.
2677.XIO2213_Win8_Recovery.docx"
I see yellow exclamation point on my "Texas Instruments 1394 OHCI Compliant Host Controller" driver, device manager gives code 10 error. I already:
-Changed PCI slots
-Reinstalled drivers
-Installed Legacy Driver
-Installed Win 8 again (in case of some viruses or something like that)
I was going to apply those steps in the word file but I don't have any exclamation point on PCI to PCI bridge. Should I try it? I don't want to ruin my Pc or FW card. Or any other solutions for this?