SN751178: VOH/VOL of SN751178

yoshiki hasebe

Part Number: SN751178

Dear Sirs,

My customer asked us about VOH/VOL of SN751178.

At the output of the Receiver circuit,
What is the certified value of Voh / Vol at current (3 mA, 5 mA, 10 mA, 16 mA, 20 mA)?

(Because、when they use this device, there is a possibility that the current may flow by 5 to 20 mA.）

Best Regards,

Y.Hasebe

over 7 years ago

0 Michael J Schultis over 7 years ago

TI__Mastermind 24885 points

Hello Yoshiki,

There will be no way to guarantee a specification for the Voh and Vol at these currents, but this can be tested for a couple of devices and typical data can be provided. Please allow a few days for data collection to give a typical value. Samples will need to be ordered. I also apologize for any delays that may be caused by the holiday season in the US.

Best,
Michael

0 Ron Michallick over 7 years ago

TI__Guru**** 150886 points

Yoshiki-san,

This load is not recommended nevertheless it should work fine.

VOL does have specifications for IOL up to 16mA. 20mA is not far beyond that.

VOH is driven by a Darlington NPN driver. So a automatic V-loss near 1.4V is expected.

After that low output impedance is expected. Eventually the 85 ohm resistor will limit current.

Collector voltage at 20mA should be about VCC - 85 ohm * 20mA = 3.3V

Output voltage will be about 2.5V

0 yoshiki hasebe over 7 years ago in reply to Michael J Schultis

Mastermind 6385 points

Hello Michael-san,

Thank you for your kindly reply.

I understand your comments.
I am waiting for your additional reply.

Best Regards,
Y.Hasebe

0 yoshiki hasebe over 7 years ago in reply to Ron Michallick

Mastermind 6385 points

Hello Ron-san,

Thank you for your kindly reply.
I have some additional questions.

1. VOL
20mA is not far beyond that.

→I understood that this is no problem.
　 Is it right?
2. VOH
Eventually the 85 ohm resistor will limit current.
Collector voltage at 20mA should be about VCC - 85 ohm * 20mA = 3.3V.

→The specification of IOH is -400 μA MAX.
　 Which current value is the above 20 mA?
　Is this an IOL?

As a result, is it no problem to flow 5-20 mA?

Best Regards,
Y.Hasebe

0 Ron Michallick over 7 years ago in reply to yoshiki hasebe

TI__Guru**** 150886 points

Yoshiki-san,

I do not expect any problems for this current range.
Please also test it yourself to make sure it satisfies your needs.

0 yoshiki hasebe over 7 years ago in reply to Ron Michallick

Mastermind 6385 points

Hello Ron-san,

Thank you for your reply.

I understand your comments.

Best Regards,
Y.Hasebe

Interface

Interface forum

SN751178: VOH/VOL of SN751178