This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.


Part Number: TPD2EUSB30


I'm using the TPD2EUSB30 ESD protection device on our board for USB 3.0 signals. The datasheet specifies pin 1 and 2 to be D+ and D- respectively. Since the circuit diagram of the diodes inside seem to be symmetrical, it appears that if need be, I could swap the D+ and D- inputs to be the opposite polarity just for the sake of layout purposes. Is that correct? Can these pins be swapped to opposite polarities?

Thank you very much