• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 32 subscribers
  • Views 203 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DS80PCI810: [DS80PCI810] The behavior changed from master mode to slave mode

Liao Rock
Prodigy 50 points
Part Number: DS80PCI810

Hi sir :

Pardon me, we have a question, when the repeater is master mode, loading code is done from EEPROM, it changes the mode from master mode to slave mode automatically.

Does the repeater load code again in slave mode ?  

Thank you.

  • 0
    TI__Mastermind 43795 points

    Hi,

    The DS80PCI810 will load the EEPROM information on power-up with READ_EN = 0 and ENSMB = Float.

    When the EEPROM information is successfully loaded and ALL_DONE# = 0, the DS80PCI810 will automatically revert to slave mode.  At this time all the information loaded by the EEPROM is retained.  There should be no change in performance during this transition.

    Once in slave mode the DS80PCI810 can be accessed with standard SMBus R/W commands to the address defined by the AD[3:0] pins.

    Regards,

    Lee