Hello Ti,
Using the UA9637A - Dual High Speed Differential Line Driver.
I am only using one of the line drivers and the other one is not used.
How do I properly terminate the differential inputs of the unused gate p5, p6?
Regards,
Chris Fisher
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hello Ti,
Using the UA9637A - Dual High Speed Differential Line Driver.
I am only using one of the line drivers and the other one is not used.
How do I properly terminate the differential inputs of the unused gate p5, p6?
Regards,
Chris Fisher
Chris,
Adding on to Eric's comment, you might choose to pull one side high (to VCC) and pull the other low (to GND). This would force the output into a fixed state. Otherwise with no defined differential input you may see some oscillating or switching on the corresponding output. This isn't an issue for the receiver, but you might want to avoid it if you are concerned about potentially coupling noise to other components on the PCB.
Regards,
Max