Other Parts Discussed in Thread: DS90CR288A,
I want to design a full mode of cameralink. Which encoding and decoding chip is recommended?
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
I want to design a full mode of cameralink. Which encoding and decoding chip is recommended?
Hello,
DS90CR288A is the accompanying deserializer for DS90CR287. But the Cameralink portfolio is somewhat old at this point and you my find the FPD Link III technology more useful depending on your application. Please see FPD Link III technology here: http://www.ti.com/interface/fpd-link-serdes/overview.html
Best Regards,
Casey
hi,Thank you for your patience
I have some questions
1. If I use 3 slices 288, can I complete the base, media, full mode?
2. A piece of 288 as a base, plus a piece of DS90C388 can be made full mode?
3. If my board is a combination of two DS90C388, the camera is 287, BASE mode, can I still solve the signal correctly?
4. If my board wants to complete BASE, meidia, full three modes, can I recommend a specific chip model?
thank you
Hello,
Please see this app note for information on the different bit assignments for camera link modes especially in section 3: http://www.imagelabs.com/wp-content/uploads/2010/10/CameraLink5.pdf
You would need 1 chip for base mode, 2 chips for medium mode, and 3 chips for full mode.
Best Regards,
Casey
Hello,
Yes those would most likely be the best parts for this application.
Best Regards,
Casey