TPD4S012: TPD4S012DRYR Layout

Jebin Satheesh Kumar

Part Number: TPD4S012

Due to space constraint i would like to route D+ signal through Pin no 5 (as PIN 5 internally not connected ). It will create any performance or stability problem in the feature?

Jebin

over 4 years ago

0 Andy Robles over 4 years ago

TI__Genius 13460 points

Hi Jebin,

Welcome to E2E!

Pin 5 is not internally connected to the device so it would be okay to route through this pin.

In the layout example in the datasheet they send the signal line D- to the bottom layer because in the example D+ also gets sent to the bottom layer to not connect with pin 6. If D+ and D- get separated it might impose a problem to the system. In your case since D+ stays in the same layer it wouldn't be a problem to route through pin 5.

Let me know if you have any more questions!

Best regards,

Andy Robles

0 Jebin Satheesh Kumar over 4 years ago in reply to Andy Robles

Intellectual 280 points

Hi Andy Robles,

Thanks for the Replay.

Jebin

Interface

Interface forum

TPD4S012: TPD4S012DRYR Layout