Dear all,
I kindly need to know if the configuration below is allowed: 5V logic slave on the buffered line between two P82B96. Total track length between two P82B96 is about 10cm + 5cm cable with two JST 1mm pitch connectors.
Many thanks
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Dear all,
I kindly need to know if the configuration below is allowed: 5V logic slave on the buffered line between two P82B96. Total track length between two P82B96 is about 10cm + 5cm cable with two JST 1mm pitch connectors.
Many thanks
Hi Daniele,
It is not common to do this since often the P82B96 is used as a way of translating the I2C signals to a higher voltage or to use a stronger pull-up resistance (i.e., a lower resistance value than a typical I2C slave may be specified to support). However, ss long as the high- and low-level voltage specifications of the slave are compatible with those of the P82B96 buffered bus this should be ok to do.
Regards,
Max