SN75LVPE4410: SN75LVPE4410

TI_pwr_usr

Part Number: SN75LVPE4410

Question on Receiver Detect State Machine:

On SN75LVPE4410, where is the Receiver Detect State Machine located, on the RX pins or TX pins? In other words, does the part initiate RXDET protocol or just a slave that response to RXDET protocol?

over 3 years ago

0 Davor Glisic over 3 years ago

TI__Expert 7935 points

Hello-

The RX detection happens of the TX side of the SN75LVPE4410. Immediately after the device power-up, a common mode RX Detect pulses are sent and the amplitude of the reflected wave measured. If a valid termination is detected on the connected PCIe receiver, the SN75LVPE4410 enables its RX terminations and linear drivers.

Regards,

Davor

0 TI_pwr_usr over 3 years ago in reply to Davor Glisic

Intellectual 280 points

Davor,

If RX side is not connected on SN75LVPE4410, does it still turn on RX termination upon detection of RXDET load impedance on TX side?

Also does the RXDET state machine run continuously if not finding a load?

Thanks..

0 Davor Glisic over 3 years ago in reply to TI_pwr_usr

TI__Expert 7935 points

Hello-

The answer is yes to both of your questions.

Regards,

Davor

Interface

Interface forum

SN75LVPE4410: SN75LVPE4410