TUSB320-HA-EVM: TUSB320-HA-EVM configuration

Li Chen92

Expert 3040 points

Part Number: TUSB320-HA-EVM
Other Parts Discussed in Thread: USB2ANY

Hi TI expert

I would like to know if I can use USB2ANY to configure a TUSB320-HA-EVM board.

Best regards,

Thomas

over 5 years ago

0 Malik Barton57 over 5 years ago

TI__Guru 64326 points

Hi Li,

Most 100 kHz or 400 kHz I2C master can be used with this device. The pin out of the USB2ANY connector may not match J1 so some jumper wires will be needed (can be connected tot J1 or J2 SDA/SCL lines).

Interface

Interface forum

TUSB320-HA-EVM: TUSB320-HA-EVM configuration