Hello,
I would like to ask if DIP switches can be used for PIN's with L0-L3 levels rather than headers as shown on the reference designs?
Thanks,
Alexandros
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hello,
I would like to ask if DIP switches can be used for PIN's with L0-L3 levels rather than headers as shown on the reference designs?
Thanks,
Alexandros
Hi Alexandros,
Sure yes this can be used. Please note correct Resistor values - as noted in data sheet - must be used along with dip switch setting. Good thing about headers is that you can use one header to set certain level. Using dip switch, there is a possibility that two dip switches could be set at the same time.
Regards,, Nasser
Regards,, Nasser