DP83TC811EVM: MATEnet Cable Assembly

EmbeddedMike

Part Number: DP83TC811EVM

I'm having a hard time figuring out how to interface with the Automotive Ethernet header (J7) on the DP83TC811EVM. I need a cable that will plug into the dev board on one end and have pigtails on the other. Here's what I've found so far:

Header (J7): TE 9-2304372-9 MATEnet Header

Frame: TE 9-2302454-9 MATEnet Frame

But the Frame is basically and empty shell, there's no pins that actually plug into the header. So then it seems like I need an additional housing that goes inside the frame?

Housing: TE 2302450-1 Housing for Female Terminals

But the Housing doesn't have the pins either so then it seems like I also need the corresponding sockets (assuming the header is male?):

Pins: TE 1-1703930-2 Nano MQS Receptacle Terminals

I would like to avoid buying all the subcomponents myself and assembling the cable so I'm hoping to find a premade cable assembly. The User Guide calls out a B-type automotive connector:

This led me to the TE Cable Spec

Is the type cable shown there what I need? Where is the best place to buy one?

over 3 years ago

0 Kallikuppa Sreenivasa over 3 years ago

TI__Guru** 121998 points

Hello Michael Adams

Thank you for the query.

We typically leverage third party vendors to support on the accessories.

Let me check and comeback if there is a part number for the cable. that you could order

FYI,

part number for the connector on the board: www.te.com/.../product-9-2304372-9.html

Regards,

Sreenivasa

0 Kallikuppa Sreenivasa over 3 years ago in reply to Kallikuppa Sreenivasa

TI__Guru** 121998 points

Matnet_Cables.xls

https://store.intrepidcs.com/product-p/matenet-cable-1.htm

https://store.intrepidcs.com/BR-CABLE-1-MINI50-p/br-cable-1-mini50.htm

Hello Michael Adams

Please check if the attached spread sheet and the links helps.

Regards,

Sreenivasa

0 EmbeddedMike over 3 years ago in reply to Kallikuppa Sreenivasa

Expert 1260 points

In the speadsheet you attached the cables have these connector options: plug, socket, pigtail.

Is a plug or socket compatible with the 9-2304372 header you mentioned? Neither seem to have the 'frame' that fits the header.

0 Kallikuppa Sreenivasa over 3 years ago in reply to EmbeddedMike

TI__Guru** 121998 points

Hello Micheal Adams,

Thank you for the mail.

Please use the links that i sent you.

The spread sheet is for reference and you can ignore the same. You could use the approach to look for cables on mouser or similar components suppliers.

Regards,

Sreenivasa

+1 EmbeddedMike over 3 years ago

Expert 1260 points

I wasn't able to find any helpful information so I ordered a cable from Mouser with the Female Insert-Module shown in TE Cable Spec image I attached in my original post. After receiving the cable and the dev board with the header in question, I was able to test it myself.

The female insert-module of the cable can plug into the header without the frame, it's snug but does not latch. The frame is optional but useful for making a more secure connection to the header. I ordered a frame for my cable and will plug the female insert-module into the frame, then the insert/frame combo into the header.

Interface

Interface forum

DP83TC811EVM: MATEnet Cable Assembly