Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: DP83826E DP83826 in Enhanced mode has a pin which is GPIO, pin 29. This pin can be an LED or can be used as CRS. When PHY is set in RMII mode, this pin can be reprogrammed to be LED or CRS. When MII is strapped, this pin is forced to be CRS…
Part Number: DP83822I
For 822/826 PHYs, Odd Nibbles Detection register need to be disable in order to prevent unexpected link loss in EtherCAT application.
DP83826PHY:
Odd Nibble Detection could be disable by strap 1 CLKOUT/LED1 pin in enhanced…
Part Number: DP83822IF Other Parts Discussed in Thread: DP83822HF , The DP83822IF and DP83822HF are the fiber capable variants of the DP83822.
Bit 2 in Register 0x0001 indicates link status for both Copper and Fiber modes of operation.
In copper mode…
Our Ethernet PHYs have a standard set of registers, 0x0-0x1F, that can be accessed in a straight forward fashion. Registers beyond 0x1F require a different approach to access.
This FAQ is intended to provide a few examples on how to read/write these…
Part Number: DP83867E When bootstrapped to be in RGMII mode, DP83867 will be in shift mode by default; not align mode. The modes will be corroborated via Reg 0x32[1:0].
