This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Part Number: DP83640T-EVK
I just received a new DP83640T Eval Board and can’t connect to it with the Analog LaunchPAD Ethernet Integrity Software Utility I downloaded from TI. I installed the software and USB driver on a Win7 laptop. I am getting the error “No attached ALP based USB boards were detected”.
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
In reply to Wolfgang Hennig:
EFL (Ethernet & FPD Link) Applications Engineer
In reply to Rob Rodrigues:
I found a post that said this ALP Software Utility doesn’t work on Win7 so I installed it on WinXP. The Software Utility now sees my DP83640 Eval Board but give me the error “Could not instantiate class DP83640_Nano_GUI from the following GUI device”.
In reply to tim Hogston:
Works for me ok now on an WinXP PC.
I can read registers without error messages
Yes, I ran the ALPUSBDriver.exe program to install the drivers. It sees the Eval board but gives me the error “Could not instantiate class DP83640_Nano_GUI from the following GUI device”.
In reply to Alex42:
I was using the 1st one on the development board page. I was able to find a WinXP machine to install it on. I never tried the other one.
Yup. I got the boards in and came to the same conclusion as everyone else. WinXP is required with the ALP found on the dev board page. I had to dust off an old computer to get it working. I even went so far as to get in touch with Opal Kelly to see if they had an updated driver, but they bounced me back to TI.
This is a bit off topic, but since you seem to also be looking at this the same time I thought I would ask you a question that i just posted about not being able to get boards discovered using the EPLTestApp or PTPTestApp that came with the dev environment.
I believe that I have my test environment set up correctly.
-I'm on a WinXP.
-Python 2.4 appears to be executing correctly.
-I have VC++ 2008 Express installed
-I'm using National Analog LaunchPAD and I'm able to see my two boards and change register values.
However, when I run either EPLTestApp.exe or PTPTestApp.exe or testit.cmd in .\tools\python\EPLTest no boards are discovered. I have copied the _epl.dll and okFrontPanel.dll in with the EXE, but still only get a 'Scan Complete!' without anything found.
I'm sure I'm doing something dumb, but nothing else is obvious. Thanks.
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.