This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TPS65986EVM: RPD_G2 connected to NC

Part Number: TPS65986EVM

Hi,

Looking at the schematic for the TPS65986EVM, RPD_G2 is connected to the L11_NC net. Is this necessary for some reason/ should we put this in?

Thanks,

Josh

  • Hi Josh,

    No this is not a requirement for the design. We did this on the EVM so that we could easily route the RPD_G2 signal to the zero ohm resistor on the top layer of the PCB. Most customers won't have this zero ohm option so they can directly route RPD_G2 to C_CC2 (K10 & L10 respectively).

    Thank you,
    Eric