LMH0303: Is it OK to set the ENABLE signal active (L → H) before the RSTI signal is released (L → H)?

Poh Kok Keng

Part Number: LMH0303

Dear Support,

For LMH0303SQ device, can I check if it is OK to set the ENABLE signal active (L → H) before the RSTI signal is released (L → H)?

Best Rgds,

Kpk

over 5 years ago

0 Nasser Mohammadi over 5 years ago

TI__Guru* 88905 points

Greetings,

This should be ok. In this case, device state machine - after reset - sees ENABLE high and activates the line driver and go into normal operating mode.

Regards,,nasser

Interface

Interface forum

LMH0303: Is it OK to set the ENABLE signal active (L → H) before the RSTI signal is released (L → H)?