This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Part Number: HD3SS3220
I am using in a new project the device: HD3SS3220IRNHR
Which is a USB Type C mux
When connecting a USB3 Thumb drive it detected as a Super Speed device
When I connecting the plug in 180deg polarity it recognized as an High Speed device
When I reconnecting the upstream or Reseting the Hub the Tomb drive is recognized as a Super Speed device,
It seems that the CC1 and CC2 are not recognized in active mode,
I also checked with oscilloscope the voltage level of one of the CC pins (CC2 I think),
The CC pin turn to low only when Detached and attached the upstream cable again or reseting the HUB for detecting properly
Please advise how can I recognized the device orientation actively,
Attached is the Schematics implementation,
Gen2 bu - USB Type C Mux 14 06 20.pdf
best way is to get a type-C cable and try with both orientation.
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
In reply to Brian Zhou:
I connected a Thumb drive Type C Super speed, isn’t the same?
Please advise if need to configure by I2C for Dynamic operation,
I also used Microchip USB3.1 hub with that TI chip but I don’t think this is the reason,
In reply to Shlomi Yehezkia:
you have couple of Type-c ports, which port has issue? DFP or UFP?
Also DIR should be 3.3v
The issue happens with the DFP ports,
probably because when disconnecting the upstream the USB HUB is initialize the communication each time it sense the upstream VBUS attached / de-attached (on the pin VBUS_DETECT)
about the DIR pin is confusing for what is the max voltage is allowed:
DIR should be 3.3v, its an error on datasheet
The DIR pin at the DFP ports are connected to 3.3V
And in the Upstream port UFP is connected to 5V
The problem is with the DFU ports which are not change state when connecting the Thumb drive in the opposite direction,
However the UFP ports (with the DIR connected to 5V) is working in both directions (as I said it might because the HUB is initialized by the USB_DETECT pin)
In reply to barak nadav:
For DFP, Vbus_det can not connect to Vbus directly.. A vbus switch is needed to control voltae to Vbus_det.. Vbu_det should be low, after an UFP is attached , ID goes low and turn on the Vbus switch to supply Vbus_det.
Your comment was helpfull,
Have a nice day,
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.