Hi Team,
What is the maximum trace length and trace impedance for below lines?
L1: GPU to cap
L2: Cap to TPD158
L3: TPD158 to HDMI connector
And any layout guides for TDP158?
Best regards,
Dylan
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi Team,
What is the maximum trace length and trace impedance for below lines?
L1: GPU to cap
L2: Cap to TPD158
L3: TPD158 to HDMI connector
And any layout guides for TDP158?
Best regards,
Dylan
Dylan
The DP158 equalizer can compensate up to 15.5dB loss on the input side. Please take a look at section 9.2.3 and you can see the DP158 is able to open up the eye after a 20in 4mil trace. On the connector side, it has a 3.5dB pre-emphasis.
Please take a look at the GPU and see if the GPU has a specific requirement on the differential impedance. If not, please follow the HDMI spec impedance of 100ohm +/- 15%.
Attached is the HDMI layout design guide.
5706.Texas Instruments HDMI Design Guide.pdf
Thanks
David