Original question:
I have design the 960 and 953 board , according the reference design , from TI web. and connect IMX327 sensor to 953.
Now I connect one 953 board to 960 board, and use the USB2ANY tool to config it .
I can access the 960 register success , but didn't access 953 register form 960.
Anyone give me a example that make these all work?
I 'm set up the FPD-LINK success, it can be view with USB2ANY tool.
I can config 953 with USB2ANY , but can't access though 960, how to do it?
And from the picture , seems FPD-LINK received the media data. but my CSI port can't see the wave by Oscilloscope.
I have access 953's register ok and probe it in code, and I have already probe the sensor(IMX219) OK .
All register access is no problem, but my SOC(imx8qm) can't get the data from mipi-csi .
I config the "7.5.12 Pattern Generation " according the datasheet but not found the video data from /dev/videox
and I test the wave with Oscilloscope， I don't know the wave normal or not? Anyone know it?
zoom the wave
In my system, a mipi sensor OV8865 used, it output RAW10 data with 4-lane mipi.
Now, the video in SOC display following, anyone give me some advice?
When I set "Patgen Fixed Colorbar 1280x720p30" mode, the output video is following , I don't know is right or wrong?
