This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Part Number: TPS65987EVM
I will like to know how to not send the VDM message with the configuration tools ?
I put the EVM board in DRP mode , and I plug à UFP device . Below you will found the message send :
Thank you in advance for your help
Are you referring to VDM message with SOP_PRIME?
If so, this is how the PD device communicating to the cable.
Whoever is providing VCONN can communicate to the cable, if you don't want then let the end partner/device provide VCONN.
We are glad that we were able to resolve this issue, and will now proceed to close this thread.
If you have further questions related to this thread, you may click "Ask a related question" below. The newly created question will be automatically linked to this question.
In reply to pdjuandi:
pdjuandiAre you referring to VDM message with SOP_PRIME?
pdjuandiWhoever is providing VCONN can communicate to the cable, if you don't want then let the end partner/device provide VCONN.
this is not possible because the device is in dead battery state.
I'm asking you this question because I use my smartphone and I didn't get any VDM message.
there is no configuration thinks to do to don't send this message ?
and for my curiosity where we configure the vdm message ?
In reply to david Laurent:
In Port Configuration (0x28) VCONN Supported field, change it to VCONN not supported (disabled)?
VDM message is part of PD policy.
I tried this but nothing change I still get the VDM message !!.
I understand the VDM is part of PD policy, but I tried different product managing the PD type usb-c, and no one send this message.
Best regards .
When powering up, whoever is the source it will also be VCONN provider initially. Do you see this message at the very beginning?
Do you see voltage on VCONN even after disabling the VCONN?
Can you send me your project file, PD log and scope capture of CC1, 2 and VBUS?
We need to know who is providing VCONN, just out of curiosity have you tried VCONN_SWAP?
All content and materials on this site are provided "as is". TI and its respective suppliers and providers of content make no representations about the suitability of these materials for any purpose and disclaim all warranties and conditions with regard to these materials, including but not limited to all implied warranties and conditions of merchantability, fitness for a particular purpose, title and non-infringement of any third party intellectual property right. No license, either express or implied, by estoppel or otherwise, is granted by TI. Use of the information on this site may require a license from a third party, or a license from TI.
TI is a global semiconductor design and manufacturing company. Innovate with 100,000+ analog ICs andembedded processors, along with software, tools and the industry’s largest sales/support staff.