Hello TI experts,
My customer considers ISOUSB211 for their new product for USB 2.0 high speed communication.
they just want to isolate function, and don't need noting more, so i suggested the diagram in figure 8.6 in datasheet.
I think it would be a best to change VBUS2 to 5V, cause both sides are USB 5V supply. please give me your opinion about this.
and I cannot find the way to set EQxx pins on the device. is it okay to set exactly same with figure 8.6? (EQ10=GND, EQ11=float, EQ20=3.3V, EQ21=GND)
or is there other options which depends on the situation?
Please check these issues above. Thanks.