How to Boot with QNX U-Boot for Jacinto6(DRA75x) evm board?

user4268977

Prodigy 80 points

Hi,

I can boot GLSDK u-boot and kernel, but I can't see any output from host terminal with QNX u-boot.

I got the images from below QNX website for TI Jacinto 6 DRA74x EVM Board Support Package.

community.qnx.com/.../TexasInstrumentsJacinto6DRA74xEVM

Bootloader modules(include MLO, u-boot.img) and QNX Neutrino 6.6.0 BSP(ifs-dra74x-vayu-evm.bin).

Can you give us some suggestions? Thanks

Regards,

Hubery.

over 9 years ago

0 Yordan Kovachev over 9 years ago

TI__Guru**** 161600 points

Hi Hubery,

This means that QNX u-boot & MLO are not made for this board...
Which revision is your board? Have you checked QNX release notes to see which J6 EVM revisions are supported by their release?

Best Regards,
Yordan

0 user4268977 over 9 years ago in reply to Yordan Kovachev

Prodigy 80 points

Now I can boot the QNX on board, copy the new images to the micro SD card:
$ cp BSP_ROOT_DIR/images/ipl-dra74x-vayu-evm.bin $SD_CARD/mlo
$ cp BSP_ROOT_DIR/images/ifs-dra74x-vayu-evm.bin $SD_CARD/qnx-ifs

Processors

Processors forum

How to Boot with QNX U-Boot for Jacinto6(DRA75x) evm board?