SN74AXCH2T45: The silk screen does not conform to the specification

?? ?

The screen printing on the physical object is 22JT, while the screen printing on the specification book is 22IT. Is there any change in the specification book? If there is any change, please help to provide the latest specification. If there is no change, please confirm why this situation occurs. thank you！

over 3 years ago

0 Michael Ikwuyum over 3 years ago

TI__Guru 61777 points

Hi,

Could you please share an image of the 22JT physical object printing? Thanks.

Best Regards,

Michael.

0 ?? ? over 3 years ago

Prodigy 10 points

Please check the physical photos

0 ?? ? over 3 years ago in reply to Michael Ikwuyum

Prodigy 10 points

Please check the physical photos， thank you

0 Michael Ikwuyum over 3 years ago in reply to ?? ?

TI__Guru 61777 points

Hi,

The datasheet is accurate. I also looked in our system and no parts come up for 22JT.

Also note that our packages are usually labelled differently (TI logo included as well) and would recommend purchasing from TI.com, thanks.

Best Regards,

Michael.

0 ?? ? over 3 years ago in reply to Michael Ikwuyum

Prodigy 10 points

This is the material purchased by Mouser. The two batches of incoming materials are silkscreen printing. Please confirm

0 Michael Ikwuyum over 3 years ago in reply to ?? ?

TI__Guru 61777 points

Hi,

I have confirmed and the device marking should be 22IT for SN74AXCH2T45. Please see below for an example of typical packages and their printing (as 22IT would typically not be the only label on the package physically; the device name, date and lot codes, as well of TI's logo would as well) and reach out to your sales contact for further clarification as we strongly recommend utilizing TI.com in the future as well, thanks.

Best Regards,

Michael.

Logic

Logic forum

SN74AXCH2T45: The silk screen does not conform to the specification