This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TXB0108: Unused Pin Connection

Part Number: TXB0108

Hi team,

According to below Q&A, unused pin in TXB0108 is recommended to be tied to GND through a weak pulldown resistors (>=100kohm).

Is it OK to bundle the pins together and connect a single pull-down resistor to the common point? Say connect two pins together and then connect a resistor of 47kohm to ground - is this OK? The equivalent resistance for each pins is slightly lower (~94kohm per pin) than the recommended 100kohm - is this OK?