SN74AXC8T245-Q1: SN74AXC8T245-Q1

guei lee

Part Number: SN74AXC8T245-Q1
Other Parts Discussed in Thread: SN74AXC8T245

We use SN74AXC8T245 to translate RGMII signals.

Port B link to PHY IC, VCCB is 1.8V.

Port A link to FPGA, the Bank voltage is 1.2V, so VCCA link to 1.2V.

Ethernet input is 1GHz, RX_CLK is 125MHz,

The issue is Outout A4, measure RX_CLK have 500mV DC level, Do you know WHY?

Thanks.

0 Michael Ikwuyum 11 months ago

Hi Guei,

This is typically due to using pull-ups. Please help confirm if removing solves the issue, thanks.

Best Regards,

Michael.

0 guei lee 11 months ago in reply to Michael Ikwuyum

Hi,Michael

Thanks your reply.

Which pull-ups should I remove?

RX_CLK signal no pull up resistor in this circuit.

Thanks.

0 Michael Ikwuyum 11 months ago in reply to guei lee

Hi Guei,

Thanks for clarifying. It seems this case is a duplicate of SN74AXC8T245: Using this as PHY to FPGA shifting (?).

If so, could you please help check with Barton Tung as we have further clarified offline? Thanks.

Best Regards,

Michael.

Logic forum