Hi team,
A-side High level voltage is higher than Vref_A.
The datasheet figure also appears to be higher than 1.8V.
Could you provide me the reason?
If this cannot be avoided, what is the voltage range?
Best regards,
Tomoaki Yoshida
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hi team,
A-side High level voltage is higher than Vref_A.
The datasheet figure also appears to be higher than 1.8V.
Could you provide me the reason?
If this cannot be avoided, what is the voltage range?
Best regards,
Tomoaki Yoshida
Hi Tomoaki,
The signal you are referencing is an input to the device so its possible it is slightly higher than 1.8 V. How much higher is the voltage? Are you pulling it up to a different supply?
I recommend watching the training videos below that cover the LSF family operation:
https://training.ti.com/introduction-voltage-level-translation-lsf-family?cu=1134826
Hi Dylan-san,
Thank you for your support.
I will explain more details.
I want to talk directly by email or private message.
I will apply for friendship, can you reply?
Best regards,
Tomoaki Yoshida
Hi Dylan-san,
I sent you a friendship request.
Please confirm it.
Best regards,
Tomoaki Yoshida
Hi Dylan-san,
I sent an email directly to you.
Have you received it?
If you have not received it, please contact me on E2E.
Best regards,
Tomoaki Yoshida
Hi Yoshida-san,
I will close this post and lock it since we've communicated over email. Thanks!