• State Resolved
  • Locked Locked
  • Replies 4 replies
  • Subscribers 18 subscribers
  • Views 1089 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

LMV7239: Comparator Schematic review

Mirok
Prodigy 210 points
Other Parts Discussed in Thread: LMV7239

Dear TI community could please review my comparator schematic.

Thank you very much.

I'm not sure is this question more like for the Logic forum or Amplifier.

Mike

  • 0
    Prodigy 210 points

    Okay, i found that with this comparator I don’t need the R12 resistor.

  • 0 in reply to Mirok
    TI__Mastermind 23395 points
    There is nothing fundamentally wrong with your circuit. You are correct that a resistor to ground is not required. The LMV7239 has a push-pull output stage that will effectively drive the output to the positive and negative supply rails. I also noticed an RC filter at the output of the comparator. That sort of anti-alias filter is needed for an amplifier before driving an ADC but it is not frequently needed at the output of the comparator. This will actually soften the edge of the comparator output. If that was the intention, no problem. Otherwise, that can be omitted as well.
    Chuck
  • 0 in reply to Chuck Sins
    Prodigy 210 points

    Dear Chuck,

    this is the whole schematic, and yes SignalOut goes to an ADC, but not on the same board, it es 15 cm away,

    connected with wires, and there is also an DC-Motor.

    Mike

     

  • 0 in reply to Mirok
    TI__Mastermind 23395 points
    Looks good Mike,
    I will close this thread out. If you need any further assistance, feel free to reply. Otherwise it would be appreciated if you could click "Resolved".
    Thanks for your question,
    Chuck