Other Parts Discussed in Thread: HALCOGEN
The FEE library or driver, from HalCogen, is based on the F021 or uses it.
I don't fully understand why one needs this FEE driver. What does it provide on top of the F021 library which is really needed to read, write the emulated EEPROM?
The virtual sectors and blocks of data, those look entirely software constructs. So can I do without it, if I just do flash word writes?
Also this is a dumb question, but is direct read access those flash locations through just mem mapped addresses (i.e, through direct load to register from 0xF0200000 etc..)? not possible because it sits on "Flash Wrapper" / Bus 2 interface or goes through VBUSM switch, unlike main flash which is direct to Cortex?
What is "Flash Wrapper" ?