Other Parts Discussed in Thread: UNIFLASH
Hello, I am Hoseong Yun from RS Automation.
I have a problem using Uniflash.
Our board uses two RM44L920 chips (daisy chain).
It also uses the XDS560v2 STM debugger.
Below is the error message.
-----[An error has occurred and this utility has aborted]--------------------
This error is generated by TI's USCIF driver or utilities.
The value is '-182' (0xffffff4a).
The title is 'SC_ERR_CTL_CBL_BREAK_NEAR'.
The explanation is:
The controller has detected a cable break that is near-to itself.
The user must connect the cable/pod to the controller.
[End: Spectrum Digital XDS560V2 STM USB Emulator_0]
what's the problem? please give me some advice.
thank you.