LP-MSPM0G3507: Unable to Plot ADC with Analog Configurator & Unable to run program with CCS

Til Schoengarth

Prodigy 175 points

Part Number: LP-MSPM0G3507
Other Parts Discussed in Thread: MSPM0G3507, LP-MSPM0L1306, SYSCONFIG

Hello everyone,

I took a new LP, used it as delivered, and tried to do the ADC Plotting in the Analog Configurator

I did the following:

Set COM Port to Application Data Port & Baud 115200

File – Load Program

Press Reconfigure Connected Device

It is saying waiting for data all the time

Here is my Output:

What is the problem here?

Additionally, in CCS 12.2, using SDK version 1.10, I imported adc12_single_conversion_LP_MSPM0G3507_nortos_ticlang

When I press debug, I have the following errors:

Thanks in Advance

Best Regards, Til

4 months ago

0 Til Schoengarth 4 months ago

TI__Prodigy 175 points

In Addition, with the LP-MSPM0L1306 I was able to plot the ADC and load the program in CCS by doing the exact same steps

+1 Sydney Smith 4 months ago in reply to Til Schoengarth

TI__Prodigy 330 points

Hello Til,

Try updating your CCS to version 12.3 and make sure you have SysConfig version 1.16.2. If the issue persists please let me know.

Regards,

Sydney

0 Til Schoengarth 4 months ago in reply to Sydney Smith

TI__Prodigy 175 points

Hi Sydney,

that solved my Problem.

Thanks a lot.

Just for reference, where could I have found this information?

Regards,

Til

0 Sydney Smith 4 months ago in reply to Til Schoengarth

TI__Prodigy 330 points

Hello Til,

I am glad that resolved your issue. When issues like this arise the best thing to do is just to search up CCS and SysConfig on the TI website, go to downloads, and it will tell you what the latest version is. If yours is not the same download it and see if issues continue. If that does not fix it submit a question like you did.

Regards,

Sydney

Arm-based microcontrollers

Arm-based microcontrollers forum

LP-MSPM0G3507: Unable to Plot ADC with Analog Configurator & Unable to run program with CCS