Part Number: MSPM0L1228-Q1
Other Parts Discussed in Thread: MSPM0L1228
Hi TI Expert,
If we want to execute the BSL by UART0 in MSPM0L1228 MCU, what will be configured in our HW side?
Is the LFCLK is necessary? Or we can use HFCLK to exeuct the BSL program?
Hi Johnson,
I'm not sure the factory BSL mean.
In our project, there may be requirement to flash the firmware into the MCU by the MCU UART0. We plan to only use a HFCLK + 16MHz Oscillator to do this.
That mean we will not use the 32768Hz oscillator in our board.
I see that in TI EVM board and capture it below for your reference. We want to remove it for we don't need real time and don't need power saving purpose. However, my concern is that it will block/limit the BSL flash feature.
Thanks for your confirmation.
