Hi ,
1. When I click Run/Debug from CCS 6 , I get the following error Message:
CS_DAP_0: Error connecting to the target: (Error -183 @ 0x0)
The controller has detected a cable break far-from itself.
The user must connect the cable/pod to the target.
(Emulation package 6.0.14.5)
Details are :
CCS version: 6.1.1.00022
XDS100v2: New , purchased through Mouser
Target : TM4C1231E6PZ
Target Board : New , Designed by us.
2. With respecting to your guidelines in " diagonosing Common Development Problems.... TM4C..."- issue #4 , Osc0 is unused and connected to ground, and points 3,4 and 5 are as recommended.
3. There is no " Test Connection" utility visible anywhere in CCS 6 desktop. Where is it?
Quick help would be greatly appreciated.
Dr.V.Nagarajan
nag@emwib.com