Texas Instruments (TI) Microcontrollers support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search for content on other microcontrollers or ask technical support questions on the extensive portfolio of microcontrollers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: AM2634
Hi,
The AM263x SDKs (both MCU+ SDK, MCAL) uses TI ARM CLANG compiler. As AM263x can be used in safety applications, safety qualification of tools is key requirement.
With this, has TI CLANG gone through any external certification standards…
Part Number: MCU-PLUS-SDK-AM243X
Hi TI Experts,
The first entry in the MPU configuration for AM263x, AM273x and AM243x contains one big section like below -
{
.baseAddr = 0x0u ,
.size = MpuP_RegionSize_2G , //for AM273x it is 4G
.attrs = {
.isEnable = 1 ,
.…
Part Number: MCU-PLUS-SDK-AM243X
Hi,
Can TI please provide plan for DMA mode support on the supported peripherals?
Currently, we see only few drivers support DMA mode. Is there plan to add support for remaining drivers/peripherals?
Part Number: AM2432 Hi TI Experts,
This is regarding the boot pins configuration requirements.
We want to know if we need explicit pull down or pull up resistor for all boot pins? We want to use QSPI(4S) boot mode and set all boot pin to 0. Do we need…
Part Number: MCU-PLUS-SDK-AM243X
Hi,
We are using GCC compiler in our previous project/platforms. We see MCU+ SDK for Sitara MCU AM2x microcontrollers support TI ARM CLANG.
Do you have any app notes, user guides for helping the migration from GCC to…
Part Number: AM2432
Hi,
Are AM2432 ALX and ALV are pin compatible. I know ALX is with lesser pin counts. But want to confirm that the available pins in ALX are same as that of ALV.
Regards
Athuljith R
Part Number: MCU-PLUS-SDK-AM243X The CPSW IP in MCU+ devices supports debug/diagnostics stats. How do I print those stats using gel files provided in the MCU+ SDK Enet LLD?
Many TM4C123x part numbers have options that include a '7' or a '7R' the end of the part.
What is the difference between devices with the '7' at the end and devices which have the '7' omitted?
What does the 'R' designate…
Part Number: TMS570LC4357
Is JTAG RTCK required for target connection?
What are the dfifference between JTAG and ETM?
Why should the nTRST signal be pulled LOW?
The JTAG connection is lost after the program is loaded to flash.
