The TI E2E™ design support forums will undergo maintenance from Sept. 28 to Oct. 2. If you need design support during this time, contact your TI representative or open a new support request with our customer support center.

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DRV8301-69M-KIT: Question about the output waveform of the kit

Part Number: DRV8301-69M-KIT

Dear team:

When the customer is testing the lab02b routine, the motor runs smoothly and can observe the saddle wave. Observe the output waveforms of each test point as follows. 

One of 3 sets of PWMxH/L:

Test the 3 test points in the image below, the waveform is as follows:

Are all the waveforms above correct? Especially the output of J11, all three are the same waveform with a duty cycle of 50%.

Best regards